What a tankless installation involves
A tankless heater needs a lot of gas for a short time. The City of Milpitas handout notes that replacing a gas storage heater with a gas tankless unit may require upsizing the gas piping to meet the tankless unit's minimum input rating. That is the most common surprise in a retrofit.
Venting is the next question. Tankless units use special sealed venting, and the city says plastic venting may be used only when the appliance is listed for it. We set the vent per the manufacturer and the California Plumbing Code.
Tank or tankless for a Milpitas home
| Question | Tank | Tankless |
|---|---|---|
| Hot water supply | Limited to the tank volume, then recovery time | Continuous while the unit is rated for the flow. |
| Footprint | Floor space, often garage or closet | Wall-mounted. |
| Gas or power demand | Moderate | High input for a short time, may need larger gas pipe. |
| Maintenance | Annual flush, anode rod | Periodic descale per manufacturer. |
| Failure mode | Tank leak | Scale, sensor or ignition problems. |
Flow limits matter when two showers and a dishwasher run together. Ask us to size the unit to your actual use.
Flushing and descaling a tankless heater
Scale from hard water builds on the heat exchanger and shortens the unit's life. The City of Milpitas 2024 water quality report lists average total hardness of roughly 57 to 110 ppm for its two supplies, about 3 to 6.5 grains per gallon, with readings as high as 168 ppm.
- Moderate hardness still scalesWater at 6 grains per gallon leaves a hard coating over time, especially when the unit runs at high temperature.
- The flushWe isolate the unit, connect a pump and circulate a descaling solution through the heat exchanger, then rinse the system.
- Follow the manufacturerEach brand states its own interval, and some require flushing to keep the warranty valid.
- A softener helpsIf your supply tests harder than average or you have an older unit, see water softener and filtration.
Tankless unit acting up?
Call and tell us the model and the error code on the display.
Signs your tankless needs service
Error codes on the display
Many codes indicate scale or a flow sensor problem. Photograph the code before you call.
Lukewarm water at low flow
Mineral scale restricts flow and heat transfer.
Noises like kettle boiling
Scale on the heat exchanger traps water and causes rumbling.
Ignition clicks but no flame
Gas supply, venting or a sensor problem.
If you are switching from a tank
The Bay Area Air Quality Management District says the zero-NOx rule for residential water heaters applies when a unit is replaced, with the compliance date moved to January 1, 2028 by its 2026 amendments. Gas tankless units draw a lot of gas, so ask about that rule before you buy.
A tank that has failed overnight needs water heater replacement first. A planned swap can be handled as a water heater installation with time to compare models.
What affects the cost of tankless work
We quote before any work.
Sources for the tankless rules
Gas sizing, venting and permit steps follow the California Plumbing Code, which is based on the Uniform Plumbing Code (UPC) and the City of Milpitas Office of Building Safety guidance. Emissions limits come from the Bay Area Air Quality Management District.
Common Questions
Yes. Bring the code and the model number to the call. Many codes point to scale, a flow sensor or ignition.
Follow your manufacturer's schedule. Many state yearly in moderately hard water, and some units need it sooner.
Usually yes. The most common limits are gas pipe size and vent routing. A permit is required.
The pan and strap rules apply to storage tanks. A tankless unit is wall-mounted per the manufacturer, and the permit inspection confirms the installation.
It depends on gas costs, space and how you use hot water. We lay out the trade-offs and do not push a unit you do not need.
